1. Basic requirements 1.1 The elevator driver must be in good health and have no personnel obstructing the work of this type of work.
1.2 The elevator driver must be qualified to pass the safety technical training of the city and the municipal quality and technical supervision safety supervision organization before being employed.
1.3 Elevator drivers must be familiar with the performance and functions of the elevators they operate, and carefully read the instructions for use and maintenance of the elevators.
1.4 Elevator drivers must operate elevators with safety approval signs.
2 Inspection and preparation before the elevator travels.
2.1 Before opening the landing door into the car, you need to pay attention to whether the car stops at this floor.
2.2 There must be sufficient lighting in the car, and the lights must be turned on before use.
2.3 Before starting work every day, run the elevator up and down for several times, and use it without any abnormality.
After the 2.4-story door is closed, it cannot be turned by hand from the outside of the landing door. When the landing door and the car door are not closed, the elevator cannot start normally.
2.5 leveling accuracy should be no significant change.
2.2.6 Clean the interior of the car, the landing doors and the visible parts of the passengers.
3. The elevator should pay attention when driving.
3.1 During the service period, you must not leave without permission. If you must leave the post or the elevator is out of service, you should disconnect the power supply and close the door.
3.2 The driver shall be responsible for supervising and controlling the load capacity of the car, and shall not overload the elevator, and the passenger elevator shall not be used as a freight elevator.
3.3 It is not allowed to load flammable or explosive dangerous goods. In case of special circumstances, it must be approved and approved by the elevator safety management personnel and safety protection measures can be formulated before shipment.
3.4 It is strictly forbidden to start or maintain the elevator maintenance and normal operation when the landing door is opened; it is also not allowed to use the maintenance operation instead of the normal elevator operation.
3.5 The safety devices such as the hall door and the floor door electrical switch of the elevator shall not be short-circuited, and other objects may not be plugged, which may cause failure and fail to play the proper safety function.
3.6 It is not allowed to use the car roof safety window and the opening of the car safety door to ship long objects.
3.7 should discourage passengers from driving, do not lean on the car door.
3.8 The top of the car top, except for the inherent equipment of the elevator, shall not be placed.
3.9 When the elevator is running, do not rub the oil, lubricate the elevator or repair the elevator parts.
3.10 Apply the twist switch or handle switch to “on†or “stop†during driving. Do not use the safety device such as power switch or limit switch to “open†or “stop†the elevator, and do not use the object to plug the control switch. Start the car up and down.
3.11 During driving, the driver and the passengers are not allowed to reach out of the car with their hands, heads and feet. It is also not allowed to reach into the hoistway with the handles, heads and feet outside the hall door to prevent rolling accidents.
4. When the following faults occur, the elevator should be immediately deactivated and reported to the management personnel or the maintenance personnel for timely repair.
4.1 floor, the elevator can not drive normally after the car door is closed;
4.2 When the elevator speed changes significantly;
4.3 layer, when the elevator is self-driving before the car door is closed;
4.4 When the direction of travel is opposite to the selected direction;
4.5 When the internal selection, leveling, rapid, summoning and finger level signals are out of order (the driver should immediately press the emergency stop button);
4.6 found abnormal noise, large vibration and impact;
4.7 When the car is under the rated load, there is a position beyond the end station and continue to run;
4.8 When the safety clamp is malfunctioning;
4.9 When any metal part that comes into contact with the elevator has an electric charge phenomenon;
4.10 When the electrical component is exposed to a hot odor due to overheating;
5 The operation of the elevator in the event of an emergency.
5.1 When the elevator safety device is operated or the external power is cut off, the passengers are told not to panic on the one hand, and it is strictly forbidden to dial the door to escape. On the other hand, the outside world is notified by the emergency alarm device in the elevator car.
5.2 If the elevator suddenly loses control and overspeed operation occurs, although it is out of control and cannot be controlled, it may cause the wire rope to break and the car to fall, or the car may automatically drive due to leakage. The driver should first press the emergency stop button. Turn on the power and stop near the floor. If the elevator continues to operate, the power should be turned back on, and the operation button will cause the elevator to run in reverse. If the car still cannot control itself, the power should be cut off again. The driver should keep calm and wait for the safety device to automatically act to stop the car. Do not jump out of the car, and tell the passengers to lift the heel, so that the weight of the whole body is supported by the toes, and hold the car by hand to prevent the car from crashing or bottoming and causing casualties.
5.3 When an electrical fire occurs, the power supply should be cut off immediately and reported to the relevant departments for rescue. Use a dry powder, 1211 or carbon dioxide fire extinguisher to save the power before the power is cut off.
5.4 When the water in the pit of the hoistway and the electrical equipment in the pit are immersed in water, all the power should be cut off before the water can be removed to prevent electric shock.
5.6 In the event of an elevator accident, the driver must immediately stop, rescue the injured person, protect the scene, the mobile site must be marked, and promptly report to the relevant departments, and wait for treatment.
6 operation after the elevator is used.
6.1 Write the operation record of the on-duty equipment, and find that the faults are transferred to the successor and relevant departments for timely processing.
6.2 Do a good job of cleaning the garbage and the door of the hall at the floor of each floor of the four-wall floor of the car.
6.3 Park the elevator at the base station, turn off the power switch in the elevator, floor indication, car lighting, close the elevator hall door, car door, prevent others from entering the car to start the elevator.
6.4 During the tide period, the base station shall be affected by tides at the end of work or work and shall be disconnected from the base station.
You can download the elevator safety management system organized by this site, which has a complete elevator operation management system.
Mini Air Fryer,Best Mini Air Fryer,Air Fryer Without Oil,Best No Oil Air Fryer
Ningbo ATAP Electric Appliance Co.,Ltd , https://www.atap-airfryer.com